WiebeTech Forensic LabDock Bedienungsanleitung PDF herunterladen (Seite 5)

WiebeTech

F o r e n s i c L a b D o c k U s e r M a n ua l ( A9 - 0 0 0 -0 0 1 1 R E V 1 . 0 ) - 5 -

1.4.1 Connect a free power cable from your computer’s power supply to the rear of LabDock

1.4.2 Attach a FireWire cable to the rear of Forensic LabDock.

1.4.3 Connect the free end of the cable to any computer running Forensic Software Utility.

1.4.4 Set the HPA/DCO behavior using Forensic Software Utility (see section 3.1 of this

manual).

1.4.5 Unplug FireWire and power from the rear of Forensic LabDock.

2. How to install the LabDock into a computer

2.1 Mount the LabDock into an empty 5 ¼” Bay inside your computer.

Do not screw

it into place until all the cables have been connected.

2.2 Connect the USB WriteBlocker using the USB port on the rear

of the LabDock.

There are 3 possible ways to do this:

• If your motherboard has an available 10-pin USB header, use the USB to

10-pin header cable.

• If no header is available, use a USB B-type to B-type cable to connect to a USB host card.

• Or, use a USB B-type to A-type cable and attach the A-type end to an available USB port on

the computer.

2.3 Connect a free power cable from your computer’s power supply to the rear

side of the LabDock.

There are two options. Use 4-pin legacy Molex power or a SATA power

cable.

Molex power connection

SATA power connection

NOTE:

You cannot use FireWire

and SATA connections at the

same time. Please unplug one

before attaching the other.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

WiebeTech Forensic LabDock Bedienungsanleitung Seite 5